Comments on: Pizza Oven Build Part 3 – The Oven Floor https://gardengeek.net/pizza-oven-build-part-3/ Gardening and Geekdom all in one place Tue, 17 May 2022 20:28:24 +0000 hourly 1 https://wordpress.org/?v=6.5.7 By: Adem https://gardengeek.net/pizza-oven-build-part-3/#comment-391 Tue, 18 May 2021 21:11:00 +0000 https://gardengeek.net/?p=866#comment-391 In reply to Allan scott.

H Allan, to be honest I’m not too sure. There are plenty of different ways of doing these things, and I just know the way that I did it.

]]>
By: Adem https://gardengeek.net/pizza-oven-build-part-3/#comment-389 Tue, 18 May 2021 21:06:08 +0000 https://gardengeek.net/?p=866#comment-389 In reply to Richard Arnold.

Hi Richard, on the next post there are some formulas for dome heights etc. A 106cm dome would have a height of 46cm, so hopefully that helps.

As for the fireclay… to be honest I’m not too sure! Hopefully you’ve found the solution!

]]>
By: Richard Arnold https://gardengeek.net/pizza-oven-build-part-3/#comment-385 Tue, 04 May 2021 15:53:06 +0000 https://gardengeek.net/?p=866#comment-385 ]]> Hi- just beginning my 1st build. Have read Simon Brooke’s book which suggests a 80cm dome with a height of 40-45cm. My dome will be approximately 100cm (approx 20% larger) is it safe to assume that I should increase the height by the same % ie. 50ish cm? Also I will be using powdered fireclay i)is it ok to mix in a cement mixer for puddling with the sand and ii) is the ratio the same – 2 parts sand to 1 of clay (dry weight) or should I reconstitute the clay first? Thanks in advance for any advice!!!🙂

]]>
By: Allan scott https://gardengeek.net/pizza-oven-build-part-3/#comment-335 Tue, 23 Feb 2021 20:29:06 +0000 https://gardengeek.net/?p=866#comment-335 In reply to jeff goforth.

Could I put a poured fire grog and fondu base in instead of fire bricks on top of a perlite insulated 40mm base on top of of my concrete worktop

]]>
By: jeff goforth https://gardengeek.net/pizza-oven-build-part-3/#comment-243 Fri, 17 Jul 2020 16:09:39 +0000 https://gardengeek.net/?p=866#comment-243 You can also wrap the wood with plastic food wrap or packing tape. I used Melamine boards and put the slick side towards the mix. Came out pretty smooth.

]]>
By: Adem https://gardengeek.net/pizza-oven-build-part-3/#comment-238 Mon, 15 Jun 2020 09:23:04 +0000 https://gardengeek.net/?p=866#comment-238 In reply to chris.

Cheers for the tips Chris. It’s all a learning experience and to be honest I like the brick border which was put there by necessity but now looks like I meant it!

]]>
By: chris https://gardengeek.net/pizza-oven-build-part-3/#comment-237 Sun, 14 Jun 2020 06:07:07 +0000 https://gardengeek.net/?p=866#comment-237 It was probaly the wood pulling the moisture from the perlite/cement that made it crumbly on the edges. For anyone reading wet the wood well before adding the mix or line the edges with polythene and pull off after.

]]>
By: Adem https://gardengeek.net/pizza-oven-build-part-3/#comment-230 Mon, 11 May 2020 20:50:10 +0000 https://gardengeek.net/?p=866#comment-230 In reply to Alex.

Hi Alex, great to hear you’re building your own pizza oven!

The mix was dry but I’m sure that there will be some moisture in the sand and in the perlite mix below that will cause the fire-clay/sand mortar to set a little.

To be honest though, you’ll will probably be fine with just sand as it is just for levelling. The great thing about building your own oven is that you can go off grid a little with some aspects, and this definitely isn’t a major aspect of the build.

I’d love to see how it’s going so feel free to ping me some photos at info@gardengeek.net if you fancy.

Good luck.

]]>
By: Alex https://gardengeek.net/pizza-oven-build-part-3/#comment-229 Sun, 10 May 2020 19:44:22 +0000 https://gardengeek.net/?p=866#comment-229 Having a go at building my own pizza oven and your guide has been great! I have a (potentially stupid) question about the leveling mix underneath the fire bricks; If it’s just a dry mix, what’s the need for including the fire clay in the mix? Will sand alone not be sufficient?
Having not bought fire clay before, I’m not sure its consistency so maybe I’m being ignorant of it’s purpose here.

Any guidance much appreciated!

]]>
By: ediblecampus https://gardengeek.net/pizza-oven-build-part-3/#comment-119 Thu, 28 Apr 2016 13:36:22 +0000 https://gardengeek.net/?p=866#comment-119 CCSU’s very own Adem has been blogging the build of his very epic pizza oven: https://t.co/FHiq4OKj4l

]]>